WM800 - WR-DCM3 - Spindle Axis Error
A spindle Axis Error may occur when repairing large wheels or wheels with tires on.
The article may solve this issue.
Please note there are two attachments, please check your serial number, to see which of the manuals should be followed
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
If a Spindle axis error occurs
while stopping the spindle. It is most likely caused
by a “too heavy load”. e.i. a big wheel or a wheel with a
tire on.
This can be fixed by changing
the settings for deceleration of the spindle. By decreasing the DEC value, the
spindle will use more time to stop.
Alternatively to this, is also select
a “Wheel with Tire” under
the spin test.
How to change the setting of the deceleration of the spindle ***Serial number ABOVE 150:
1)
At the main menu press
2)
At the setup screen press
change DEC for spindle
3) When setting is changed press “Exit
4)
Now machine is ready to make a “heavy load” operation
We recommend, after finishing the heavy load operation, to change back to normal
settings by pressing
“Load Factory Default”
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
IF a Spindle axis error occurs while stopping the spindle. It is most likely caused by a “too heavy load”. e.i. a big wheel or a wheel with a tire on.
This can be fixed by changing the settings for deceleration of the spindle. By decreasing the DEC value, the spindle will use more time to stop.
In
case of a spindle error caused by other than this, please contact WheelRestore Serviceplatform.
1)
At
the main menu press
2)
At
the setup screen press
3)
At
the settings screen, change DEC for spindle
4)
When setting is changed press “Exit”
5)
At the Setup screen press “Exit Setup”
6)
Now machine is ready to make a “heavy load” operation
We
recommend, after finishing the heavy load operation, to change back to normal settings by pressing
“Load Factory Default