Categories
WM800 - WR-DCM3 - Maintenance manual
We strongly
recommend that the machine has a yearly service interval performed by a
manufacturer-approvedservice technician.
Axis
Cleaning
The product must be inspected and cleaned at regular intervals.
▸ Do not use compressed air for cleaning. But instead
use a brush or vacuum cleaner.
▸ Remove
large particles and dirt from the surface at regular intervals.
▸ Use only
neutral cleaning agents for cleaning.
▸ Use only
damp, soft and lint-free cleaning cloths to wipe the surface.
Cover strip The cover strip is Teflon-coated. The friction causes abrasion on the
cover strip.
▸ Remove
abrasion products at regular intervals.
Lubricating the linear guide and the drive elements
The ball screw axis is lubricated with grease from an internal
reservoir. The reservoir is factory-prefilled. The carriage features 3 grease
nipples at each side for relubrication.
•
The outer
grease nipples are used to lubricate the linear guide.
•
The inner
grease nipples are used to fill the drive element (ball screw drive).
Linear guide
|
Size |
Lubricant 1) |
Relubrication volume |
Strokes |
|||||||||
|
PAS42 |
Microlube GL 261 |
0.25 cm3 (0.02 in3) |
1/2 |
|||||||||
|
|
1) |
Alternative grease K1N-30 as per
DIN 51825 |
|
|||||||||
|
|
|
|
||||||||||
|
Ball screw drive |
|
|||||||||||
|
|
||||||||||||
|
Size |
Lubricant 1) |
Relubrication volume |
Strokes |
|||||||||
|
PAS42 |
Microlube GL 261 |
1.5 cm3 (0.09 in3) |
3 |
|||||||||
|
|
1) Alternative grease K1N-30 as per DIN 51825 |
|
||||||||||
|
Notes on greasing |
When applying the lubricant, you
must not exceed a maximum flow rate. Therefore, the minimum injection time of
3 seconds per grease gun stroke must be adhered to. |
|
|||||||||||
The carriage
must be moved between strokes of the grease gun to allow the grease to
distribute evenly in the lubricant reservoirs.
Axis cleaning
Axis belt inspection and adjustment
Axis belt inspection and adjustment
We recommend checking and adjusting the X-belt frequently. Please follow the following
steps:
1.
Put the axis in the loading position
2.
Open the door
3.
Switch off the power by removing
the plug from the socket
4.
Wait for 5 min to be sure the power is completely down
Locate the white belt (See
below RED arrow)
